Clean the spray tank before using. If it is contaminated with other materials, mixing problems and/or clogging may occur, or injury to the turf may result. 2. Prepare no more spray mixture than is required for the immediate operation. 3. Fill the spray tank 1/4-1/2 full with clean water and begin agitation. Make certain that the agitation system is working properly and creates a rippling or rolling action on the water surface. Maintain agitation throughout the mixing and spraying process.Liquid fertilizer may replace part or all of the water as carrier. The application of Monument 75WG using liquid fertilizer as the carrier may increase the herbicidal activity on certain weeds and decrease tolerance of desirable turfgrass species. This combination should be tested to determine safety of Monument 75WG and liquid fertilizer before treating large areas. 5. Add any products packaged in water-soluble film to the tank first. Allow the packets to completely dissolve and the contents of the packets to fully disperse into the mix water. Important: Water-soluble packets must always be the first material put into the spray tank after water. For products packaged in water-soluble packaging, do not tank mix with products containing Boron or mix in equipment previously used to apply a product mixture containing Boron unless the tank and spray equipment has been thoroughly cleaned. (See Instructions for Cleaning Spray Equipment After Application). 6. Add the required amount of Monument 75WG to the spray tank while maintaining agitation. Allow the product to wet and thoroughly disperse into the mix water. 7. While maintaining agitation, continue filling the spray tank. When the tank is 3/4 full, add any tank mix partners. Add any water-dispersible granule or other dry formulation first, and allow that material to disperse. Then add any emulsifiable liquid formulation.